SPECIFICATION :
Model No.: KP-012260SFX; 260Watts
Input Voltage: 12VDC ( 9VDC ~ 17VDC)
ENVIRONMENTAL CONDITIONS:
Cooling: Forced Air-cooling, 60x60x25 mm Fan x 1 (Two Ball Bearing mode)
Operating Temperature: 0 C ~ +50 C (-20 C~ +60 C optional)
Operating Humidity: 20%~85% RH. (Non condensing)
Storage Temperature: -20 C~+80 C
Storage Humidity: 10%~90% RH. (Non condensing)
Operating Altitude: 10M Below Sea level and 3000M Above Sea level
DC INPUT CHARACTERISTICS:
Polarity
Reverse Protection: None
Input connector type: 30A/ 300V UL Approved Gold Plated Brass 1.2t/3+3 Pin Terminal
Input Current: 20.5A/39A(max.) @ Full Load High Line/ Low Line
Inrush Current: Less than 50A Cold start @25 C ambient
DC OUTPUT CHARACTERISTICS:
Output Voltage |
Regulation |
Output Current |
Ripple & Noise |
Load |
Line |
Cross |
Min. |
Max. |
+5V |
3% |
1% |
5% |
1A |
28A |
50mV |
+12V |
0.5A |
20A |
120mV |
+3.3V |
0A |
16A |
50mV |
-12V |
8% |
0.1A |
1A |
120mV |
+5Vsb |
5% |
0.1A |
2A |
50mV |
*The total output
wattages shall not exceed 260 W.
*The max. combined output wattages of +3.3V & +5V shall not exceed 180 wattages.
*The max. combined output wattages of +3.3V ,+5V and +12V shall not exceed 238 wattages. |
OVERALL PERFORMANCE:
Efficiency: 65% typical @12V DC Full Load
Power Good Signal: TTL Compatible signal, on delay 100~500ms, off delay 1ms min
Short Circuit Protection (SCP): All output equipped with SCP (shutdown and
latch off)
Over Power Protection (OPP): Peak power protected to 130% 10% of continuous
rated power (shutdown and latch off)
Over Voltage Protection (OVP): +5V, +12V & +3.3V
RELIABILITY:
MTBF (Mean Time Between Failure): >100,000 hours @max. Load, 12V DC & 25 C
ambient
Safety Standards: Meet UL60950 and T V EN60950
EMI Compatibility (EMC) Standard: FCC Part 15 Class B, CISPR22 (EN55022)
Class B(CE
mark)
Dielectric Withstand: Input to Output: 500Vac for 1 second
Dielectric Withstand: Input to Frame ground: 500Vac for 1 second
Leakage Current: <0.005uA @12VDC
Output Connector specific:
ATX 24 Pin x 1: Molex29-01-2240 or equivalent
+12V(P4) 4 pin x1: Molex 39-01-2040 or equivalent
HDD, DVD 4 pin x8: Molex 8981-04P or equivalent
FDD 4 pin x1: AMP171822-4 or equivalent
Serial ATA x2: Molex 675820000 or equivalent
Process EPS 8 pin x1: Molex 39-01-2080 or equivalent
Standard Output Cable Length:
270mm (10.62 Inches)
Power Chassis Dimension:
125(W) x 130(L) x 67(H) mm
or
4.92(W) x 5.11(L) x 2.64(H) Inches
Screw Hole :
Front Panel with 4 screw holes
Rear panel bracket with 2 screw holes
Net Weight:
1.56kgs (3.5 lbs)/pc
Gross Weight:
2.3kgs (5 lbs)/pc
Packing Detail
8pcs/Carton
Measurement of Carton
0.049 cuM (1.49cu ft)