SPECIFICATION :
•
Model No.: KP-220400-I; 400Watts
•
Input Voltage: ±220VDC (±190VDC ~ ±245VDC)
ENVIRONMENTAL CONDITIONS:
• Cooling: Forced Air-cooling, 40x40x28 mm Fan x 2 (Two Ball Bearing mode)
• Operating Temperature: 0°C ~ +50°C (-20°C~ +60°C optional)
• Operating Humidity: 20%~85% RH. (Non condensing)
• Storage Temperature: -20°C~+80°C
• Storage Humidity: 10%~90% RH. (Non condensing)
• Operating Altitude: 10M Below Sea level and 3000M Above Sea level
DC INPUT CHARACTERISTICS:
• Polarity
Reverse Protection: Protected (Max. 500VDC)
• Input connector type: 40A/ 300V Single table type Terminal x2
• Input Current: 1.9A/2.5A(max.) @ Full Load High Line/ Low Line
• Inrush Current: Less than 10A Cold start @25°C ambient
DC OUTPUT CHARACTERISTICS:
|
Output Voltage |
Regulation |
Output Current |
Ripple & Noise |
|
Load |
Line |
Cross |
Min. |
Max. |
|
+5V |
±5% |
±1% |
±5% |
0A |
40A |
50mV |
|
+12V |
0A |
30A |
120mV |
|
+3.3V |
0A |
25A |
50mV |
|
-5V |
|
|
|
|
-12V |
±8% |
0A |
1A |
120mV |
|
+5Vsb |
±5% |
0A |
2A |
50mV |
|
*The total output
wattages shall not exceed 400 W.
*The max. combined output wattages of +3.3V, +5V and +12V shall not exceed 370 wattages.
|
OVERALL PERFORMANCE:
• Efficiency: 70% typical @220V DC Full Load
• Power Good Signal: TTL Compatible signal, on delay 100~500ms, off delay 1ms min
• Short Circuit Protection (SCP): All output equipped with SCP (shutdown and
latch off)
• Over Power Protection (OPP): Peak power protected to 130%±10% of continuous
rated power (shutdown and latch off)
• Over Voltage Protection (OVP): +5V, +12V & +3.3V
RELIABILITY:
• MTBF (Mean Time Between Failure): >80,000 hours @max. Load, 220V DC & 25°C
ambient
• Safety Standards: Meet UL60950 and TüV EN60950
• EMI Compatibility (EMC) Standard: FCC Part 15 Class B, CISPER22 (EN55022)
Class B(CE mark)
• Dielectric Withstand: Input to Output: 1500Vac for 1 second
• Dielectric Withstand: Input to Frame ground: 1500Vac for 1 second
• Leakage Current: <0.005uA @220VDC
Output Connector specific:
• ATX 24 Pin x 1: Molex29-01-2240 or equivalent
• +12V(P4) 4 pin x1: Molex 39-01-2040 or equivalent
• HDD, DVD 4 pin x7: Molex 8981-04P or equivalent
• FDD 4 pin x1: AMP171822-4 or equivalent
• Serial ATA x2: Molex 675820000 or equivalent
• Process EPS 8 pin x1: Molex 39-01-2080 or equivalent
Standard Output Cable Length:
• 600mm (24" ) ±20mm (0.78")
Power chassis Dimension:
• 100(W) x 205(L) x 40.5(H) mm
or
• 3.94(W) x 8.07(L) x 1.59(H) Inches
Net Weight:
• 2.2kgs (4.84 lbs)/pc
Gross Weight:
• 2.4kgs (5.28 lbs)/pc
Packing Detail
• 10 pcs/Carton
Measurement of Carton
• 0.049 cuM (1.49 cu ft)
